DRE Echo CO2
DRE · Model Echo CO2
5.7 inch high resolution display for easy reading Lightweight, portable design and user-friendly interface for easy operation Flexible configurations to meet different clinical needs PR measurement Respironics Loflo sidestream or CAPNOSTAT 5 EtCO2 mainstream measurement Powerful storage capacity Real-time parameters measurement display with trend table for easy reviewing Built-in rechargeable Lithium-ion battery for 10 hours continuous working Bi-directional communications with central station by wired or wireless network.
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
EtCO2 reading drift / needs calibration
HighSymptoms: EtCO2 does not match a reference, slow response, baseline offset.
Root cause: CO2 sensor aging, or the user CO2 calibration not performed.
No CO2 waveform
MediumSymptoms: Flat trace, occlusion or "check adapter" message.
Root cause: Blocked / wet airway adapter or sample line, or a sensor-cable fault.
SpO2 no signal (if fitted)
MediumSymptoms: No saturation value with a good site.
Root cause: SpO2 sensor or cable fault.
Battery / power fault
MediumSymptoms: Short run time, will not power on.
Root cause: Depleted or aged battery.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
CO2 sensor / bench
Class Periodic replacementRel. cost $$$R&R Moderate
Airway adapters
Class ConsumableRel. cost $R&R Easy
Sample line / water trap
Class ConsumableRel. cost $R&R Easy
SpO2 sensor and cable
Class Frequent wear itemRel. cost $$R&R Easy
Battery
Class Frequent wear itemRel. cost $R&R Easy
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| CO2 sensor / bench | Periodic replacement | $$$ | Moderate |
| Airway adapters | Consumable | $ | Easy |
| Sample line / water trap | Consumable | $ | Easy |
| SpO2 sensor and cable | Frequent wear item | $$ | Easy |
| Battery | Frequent wear item | $ | Easy |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: CO2 value looks wrong
- Perform the user CO2 calibration.
- Verify against a known CO2 reference.
- Fit a fresh airway adapter / sample line and clear moisture.
- Replace the CO2 sensor if it will not calibrate or hold zero.
- Re-verify before use.
Symptom: No waveform
- Fit a clean, dry adapter or fresh sample line and trap.
- Check the sensor cable.
- Confirm the sampling pump runs (sidestream).
- Replace the sensor if there is still no signal.
- Confirm a normal capnogram.
Technical Specs
- Height
- 241
- Length
- 200.8
- Weight
- 3 kg
- Width
- 189
Documents & Manuals
No documents available for this device yet.
Troubleshoot this device with Bio
Describe a symptom or error code. Bio answers from this device's own documented error codes, failure modes, parts, and guides.
Ask Bio