Gaymar TP-200
Gaymar · Model TP-200
Low water alarm and shut off Pump has two limit thermostats which will shut off the pump automatically if the high-temperature limit is exceeded Temperature settings of 85-105 degrees F (30-41 degrees C)
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
Pump not running / no flow / pad not cold
HighSymptoms: Pump silent or running with no water movement, pad not cooling.
Root cause: Air lock, insufficient ice / water, a kinked hose, a clogged filter, low power, or the unit below the pad.
Clogged filter / weak flow
MediumSymptoms: Flow drops over time, uneven pad temperature.
Root cause: Debris in the inlet filter.
Pad / cuff will not fill or hold
MediumSymptoms: Pad does not fill, or a Cryo/Cuff will not stay pressurised.
Root cause: Air lock, pad above the unit, or a leak in the pad / cuff.
Leak at the connector or lid
LowSymptoms: Water around the unit.
Root cause: Worn connector or lid seal.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
Circulation pump
Class Periodic replacementRel. cost $$R&R Moderate
Inlet filter
Class Frequent wear itemRel. cost $R&R Easy
Therapy pad / cuff
Class Frequent wear itemRel. cost $$R&R Easy
Hose / connector seals
Class Periodic replacementRel. cost $R&R Easy
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| Circulation pump | Periodic replacement | $$ | Moderate |
| Inlet filter | Frequent wear item | $ | Easy |
| Therapy pad / cuff | Frequent wear item | $$ | Easy |
| Hose / connector seals | Periodic replacement | $ | Easy |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: No flow / pad not cold
- Ensure the reservoir has both ice and water; allow ~10 minutes to stabilise.
- Confirm power and that plugs are fully engaged, and the hose is not kinked.
- Disconnect and reconnect the pad and release trapped air at the connector.
- Place the unit on a raised surface and loosen wraps.
- Clean the inlet filter and reassemble.
Symptom: Pad / cuff will not fill
- Lay the pad flat and below the unit and let it fill.
- Release air at the connector.
- Check the pad / cuff for a leak.
- Reapply once filled.
- Replace the pad / cuff if it will not hold.
Documents & Manuals
No documents available for this device yet.
Troubleshoot this device with Bio
Describe a symptom or error code. Bio answers from this device's own documented error codes, failure modes, parts, and guides.
Ask Bio