Gymna Cryoflow ICE-CT
Gymna · Model Cryoflow ICE-CT
Unique infrared feedback system 52 pre-programmed settings based on indications or objectives User friendly with no refilling Short treatment duration due to powerful temperature reduction Two treatment methods: static and handsfree or dynamic and manual.
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
Air stream not cold enough
HighSymptoms: Treatment air well above the expected sub-zero output, long treatment times, poor cooling effect.
Root cause: Refrigeration compressor weak, low refrigerant, or a fouled condenser.
Weak or no airflow
HighSymptoms: Little air from the applicator, flow alarm.
Root cause: Blower/fan fault, blocked intake filter, or a kinked hose.
Infrared skin-feedback fault
MediumSymptoms: Programs that use IR feedback stop early, over- or under-cool, temperature readout implausible.
Root cause: IR sensor in the handpiece contaminated or failed.
Hose / applicator damage
LowSymptoms: Cold loss along the hose, cracked applicator nozzle.
Root cause: Age and flexing of the insulated delivery hose.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
Refrigeration compressor
Sealed-system work; refrigeration certification required.
Class Major service partRel. cost $$$$R&R Expert-level
Blower / fan
Class Major service partRel. cost $$R&R Moderate
Intake air filter
Class Frequent wear itemRel. cost $R&R Easy
Infrared feedback sensor
Class Major service partRel. cost $$R&R Moderate
Insulated delivery hose / applicator
Class Periodic replacementRel. cost $$R&R Fairly easy
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| Refrigeration compressor Sealed-system work; refrigeration certification required. | Major service part | $$$$ | Expert-level |
| Blower / fan | Major service part | $$ | Moderate |
| Intake air filter | Frequent wear item | $ | Easy |
| Infrared feedback sensor | Major service part | $$ | Moderate |
| Insulated delivery hose / applicator | Periodic replacement | $$ | Fairly easy |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: Air not cold enough
- Clean or replace the intake filter and clear the condenser airflow.
- Confirm the compressor runs and the condenser fan works.
- Measure the output air temperature after a few minutes of run time.
- If output stays warm with good airflow, refer for refrigeration service.
- Re-verify the output temperature after repair.
Symptom: Weak airflow
- Check the hose for kinks and the applicator for blockage.
- Confirm the blower runs.
- Replace the intake filter.
- Replace the blower if airflow is still low.
- Verify flow at the applicator and that IR-feedback programs run to completion.