Zimmer Cryo 6
Zimmer · Model Cryo 6
The cold air device world leader Cryo 6 is intended to minimize pain and thermal injury during laser and dermatological treatments for temporary topical anesthetic relief during injections.
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
Air stream not cold enough
HighSymptoms: Treatment air well above the expected sub-zero output, long treatment times, poor cooling effect.
Root cause: Refrigeration compressor weak, low refrigerant, or a fouled condenser.
Weak or no airflow
HighSymptoms: Little air from the applicator, flow alarm.
Root cause: Blower / fan fault, blocked intake filter, or a kinked hose.
Hose / applicator damage
MediumSymptoms: Cold loss along the hose, cracked applicator nozzle.
Root cause: Age and flexing of the insulated delivery hose.
Control / display fault
LowSymptoms: Flow-level or timer setting unresponsive.
Root cause: Control board or a keypad fault.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
Refrigeration compressor
Sealed-system work; refrigeration certification required.
Class Major service partRel. cost $$$$R&R Expert-level
Blower / fan
Class Major service partRel. cost $$R&R Moderate
Intake air filter
Class Frequent wear itemRel. cost $R&R Easy
Insulated delivery hose / applicator
Class Periodic replacementRel. cost $$R&R Fairly easy
Control board
Class Major service partRel. cost $$$R&R Moderate
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| Refrigeration compressor Sealed-system work; refrigeration certification required. | Major service part | $$$$ | Expert-level |
| Blower / fan | Major service part | $$ | Moderate |
| Intake air filter | Frequent wear item | $ | Easy |
| Insulated delivery hose / applicator | Periodic replacement | $$ | Fairly easy |
| Control board | Major service part | $$$ | Moderate |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: Air not cold enough
- Clean or replace the intake filter and clear the condenser airflow.
- Confirm the compressor runs and the condenser fan works.
- Measure the output air temperature after a few minutes of run time.
- If output stays warm with good airflow, refer for refrigeration service.
- Re-verify the output temperature after repair.
Symptom: Weak airflow
- Check the hose for kinks and the applicator for blockage.
- Confirm the blower runs.
- Replace the intake filter.
- Replace the blower if airflow is still low.
- Verify flow at the applicator.
Documents & Manuals
No documents available for this device yet.
Troubleshoot this device with Bio
Describe a symptom or error code. Bio answers from this device's own documented error codes, failure modes, parts, and guides.
Ask Bio