Philips IntelliVue NMT Module
Philips Healthcare · Model IntelliVue NMT Module
Know the depth and duration of neuromuscular block to intubate and extubate with increased confidence Provides the information needed to help avoid recurarization effects in the PACU and ICU Supports the correct dosage of blocking or reversal agents The NMT module plugs into the IntelliVue monitor, and uses a single, one-piece cable.
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
EEG / NMT signal quality poor
HighSymptoms: High SQI / EMG or NMT stimulation error, noisy or flat trace, index / TOF value unreliable.
Root cause: Sensor / electrode contact or expiry, the patient interface cable, or a DSC / module fault.
Module not recognised by the host
MediumSymptoms: Host monitor (IntelliVue / MP series) does not display the module or MMS.
Root cause: Docking / rack connector or cable fault.
NIBP will not measure or is inaccurate
MediumSymptoms: NIBP times out, cuff will not inflate / hold, readings implausible.
Root cause: Internal NIBP pump or valve, a cuff / hose leak, or a pressure-transducer fault.
Cable / connector wear
LowSymptoms: Intermittent signal with cable movement.
Root cause: Worn patient cable.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
Patient cable set
Class Frequent wear itemRel. cost $$R&R Easy
Sensor / patient interface cable
Class Frequent wear itemRel. cost $$R&R Easy
Module input board
Class Major service partRel. cost $$$R&R Difficult
Module / MMS docking connector
Class Major service partRel. cost $$R&R Moderate
Internal NIBP pump / valve
Class Major service partRel. cost $$$R&R Difficult
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| Patient cable set | Frequent wear item | $$ | Easy |
| Sensor / patient interface cable | Frequent wear item | $$ | Easy |
| Module input board | Major service part | $$$ | Difficult |
| Module / MMS docking connector | Major service part | $$ | Moderate |
| Internal NIBP pump / valve | Major service part | $$$ | Difficult |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: A parameter drops out
- Reseat the patient cable at the module.
- Swap in a known-good cable for that parameter.
- Dock the module on a different host / slot to isolate module vs host.
- Inspect the docking connector for bent pins.
- Replace the cable or refer the module if the fault stays with it.
Symptom: Module not recognised
- Reseat the module / MMS at the host or rack.
- Inspect the docking connector for bent pins.
- Try it in another host or slot.
- Try a known-good module in this slot.
- Refer the module or host slot as isolated.
Technical Specs
- Height
- 3.9 in
- Length
- 3.8 in
- Weight
- 10.6 oz
- Width
- 1.4 in
Documents & Manuals
No documents available for this device yet.
Troubleshoot this device with Bio
Describe a symptom or error code. Bio answers from this device's own documented error codes, failure modes, parts, and guides.
Ask Bio