Lutronic Healite II
Lutronic · Model Healite II
Can be used after aesthetic Txs to reduce erythema and edema by up to 50% Stand-alone Txs can be used for wound healing and muscle relief via increased blood flow Comfortable, hands-free, Spa-like Tx adds clinical benefits to aesthetic patient results Differentiates practice and provides high ROI services for better outcomes.
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
Low or uneven light output
HighSymptoms: Measured output below spec, uneven across the panel / applicator, slow or ineffective treatment.
Root cause: LED / IPL lamp aging or partial failure, a driver fault, or a dirty emitting surface / filter.
LED / lamp module or driver failure
MediumSymptoms: Part or all of the array out, flicker, will not reach full output.
Root cause: Failed LED segment / IPL flashlamp or the driver / power supply.
Cooling / thermal shutdown (IPL)
MediumSymptoms: Handpiece over-temperature, unit inhibits pulses.
Root cause: Handpiece coolant / TEC or a chiller fault.
Timer / dosimetry / control fault
MediumSymptoms: Treatment timer or the output readout implausible, will not set parameters.
Root cause: Control board or a sensor fault.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
LED array / IPL flashlamp
Class Periodic replacementRel. cost $$$R&R Moderate
Driver / power supply
Class Major service partRel. cost $$R&R Moderate
Emitting-surface filter / light guide
Class Periodic replacementRel. cost $$R&R Fairly easy
Handpiece coolant / TEC (IPL)
Class Periodic replacementRel. cost $$R&R Moderate
Control board
Class Major service partRel. cost $$$R&R Difficult
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| LED array / IPL flashlamp | Periodic replacement | $$$ | Moderate |
| Driver / power supply | Major service part | $$ | Moderate |
| Emitting-surface filter / light guide | Periodic replacement | $$ | Fairly easy |
| Handpiece coolant / TEC (IPL) | Periodic replacement | $$ | Moderate |
| Control board | Major service part | $$$ | Difficult |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: Low or uneven output
- Measure output with the appropriate meter at the treatment plane.
- Confirm the whole array / lamp is firing.
- Clean the emitting surface / light guide and check the filter.
- Replace failed LED segments or the flashlamp.
- Re-measure and document the output.
Symptom: Array / lamp or driver failure
- Confirm mains power and the driver output.
- Isolate a dead segment / lamp vs whole-array failure.
- Replace the driver if unpowered.
- Replace the LED module / flashlamp for a failed emitter.
- Verify full, even output and correct the timer.
Documents & Manuals
No documents available for this device yet.
Troubleshoot this device with Bio
Describe a symptom or error code. Bio answers from this device's own documented error codes, failure modes, parts, and guides.
Ask Bio