Hillrom Likorall 250 Overhead Lift
Hillrom · Model Likorall 250 Overhead Lift
Quick-release Hook Q-Link and Quick-release Hook provide for quick sling bar changes. Planned transfers Can be equipped with a special carriage for planned transfers between different rooms. Hand Control Wireless hand control option. Lifting interval Lifting interval 200 cm (79 in) - handles lifts from the floor in most environments. Charging Simple wall charging via hand control or, alternatively, charging from the ceiling rail. Emergency Lowering Electrical emergency lowering.
Key tips
- ·Mounting and securement hardware takes real fatigue from vibration and road shock - inspect it as carefully as the device itself.
- ·Post-call battery and function checks catch transport-induced faults that a scheduled PM would miss for months.
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
Hand control not responding / no powered movement
HighSymptoms: Lift / lower / (Sara/Sabina) seat or leg functions do not respond to the hand control.
Root cause: Discharged or mis-inserted battery, an active emergency stop, an obstruction or overload, or a faulty hand control / cable.
Actuator / drive fault
MediumSymptoms: One movement will not run, runs one direction only, noisy or slow.
Root cause: Worn linear actuator or a limit-switch fault.
Battery will not hold charge
MediumSymptoms: Short run time, frequent low-battery, unit dies mid-transfer.
Root cause: Aged battery pack or a charger / charging-contact fault.
Sling / attachment-point / seat-belt wear
HighSymptoms: Sling loops fraying, sling bar hook worn, seat belt frayed, attachment not secure.
Root cause: Wear - inspect before every use and retire per Hillrom / Arjo guidance.
Caster / brake fault
LowSymptoms: Hard to move, a caster seized, brake will not hold.
Root cause: Debris or a worn caster / brake.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
Rechargeable battery pack
Class Periodic replacementRel. cost $$R&R Easy
Hand control
Class Periodic replacementRel. cost $$R&R Easy
Linear actuator
Class Major service partRel. cost $$$R&R Difficult
Caster set
Class Periodic replacementRel. cost $R&R Fairly easy
Slings / seat belts / lifting accessories
Inspect before every use; retire per Hillrom / Arjo guidance.
Class Periodic replacementRel. cost $$R&R Easy
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| Rechargeable battery pack | Periodic replacement | $$ | Easy |
| Hand control | Periodic replacement | $$ | Easy |
| Linear actuator | Major service part | $$$ | Difficult |
| Caster set | Periodic replacement | $ | Fairly easy |
| Slings / seat belts / lifting accessories Inspect before every use; retire per Hillrom / Arjo guidance. | Periodic replacement | $$ | Easy |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
PM Checklist
Preventive-maintenance tasks typical of this equipment class. Perform to the manufacturer's procedure and your facility's policy - this is general reference, not a schedule for this specific unit.
- ·Post-call function and battery check
- ·Mounting / securement inspection
- ·Annual full PM and vibration-tolerance check
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: Hand control not responding
- Confirm a charged, correctly inserted battery.
- Clear any obstruction and check the load is within the rated limit.
- Confirm the emergency stop is inactivated.
- Reseat the hand-control plug; try the buttons on the unit if fitted.
- If the unit buttons work, replace the hand control; if not, use the emergency lowering and call qualified personnel.
Symptom: One movement will not run
- Test the movement from the control panel to isolate the hand control.
- Check that motion's limit switches and wiring.
- Listen for the actuator motor.
- Replace the actuator if it will not run under command.
- Load-test to the rated limit and confirm all safety stops work.
Typical Location
Where this class of equipment is typically deployed - general reference, not this unit's own placement record.
- Ambulance / transport vehicles
- Emergency Department
- Inter-facility transport teams
Documents & Manuals
Troubleshoot this device with Bio
Describe a symptom or error code. Bio answers from this device's own documented error codes, failure modes, parts, and guides.
Ask Bio