Diego
Gyrus ACMI, LLC · Model 70338000R
DIEGO POWER DISSECTOR CONSOLE REFURBISHED.
Intended use: A hand-held component of an electrosurgical system intended to provide an electrical connection between the system generator and a detachable electrode at its distal end, enabling the surgeon controlled manipulation of the electrode during surgery; the electrode is not included. The device is typically in the form of a pen with permanently attached cables for connection to the generator; it is not intended for use during inert gas-enhanced electrosurgery. This is a reusable device.
Key tips
- ·When no category-specific guidance fits, default to the manufacturer's own service manual and the general troubleshooting method in the Engineer's Guide.
- ·Run an incoming and annual electrical safety test regardless of how niche the device is.
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
No or weak handpiece rotation / oscillation
HighSymptoms: Microdebrider blade does not spin / oscillate, weak cutting, speed not reaching set.
Root cause: Handpiece motor / drive coupling wear, a damaged blade, or a console drive fault.
Suction / irrigation fault at the blade
MediumSymptoms: Poor suction clearance, no irrigation, blade clogging.
Root cause: Blocked blade lumen, a suction-line / canister issue, or an irrigation pump fault.
Footswitch / control fault
MediumSymptoms: Console does not respond to the footswitch, mode / direction will not change.
Root cause: Footswitch or control-board fault.
Handpiece not recognised
MediumSymptoms: Console will not enable the handpiece, connection error.
Root cause: Handpiece connector wear or a cable fault.
Console / display fault
LowSymptoms: Unresponsive display, will not power on.
Root cause: Power supply or control board.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
Handpiece / motor assembly
Class Periodic replacementRel. cost $$$R&R Fairly easy
Single-use blades
Class ConsumableRel. cost $$R&R Easy
Footswitch
Class Periodic replacementRel. cost $$R&R Fairly easy
Irrigation pump / tubing
Class Periodic replacementRel. cost $$R&R Moderate
Power supply / control board
Class Major service partRel. cost $$$R&R Difficult
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| Handpiece / motor assembly | Periodic replacement | $$$ | Fairly easy |
| Single-use blades | Consumable | $$ | Easy |
| Footswitch | Periodic replacement | $$ | Fairly easy |
| Irrigation pump / tubing | Periodic replacement | $$ | Moderate |
| Power supply / control board | Major service part | $$$ | Difficult |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
PM Checklist
Preventive-maintenance tasks typical of this equipment class. Perform to the manufacturer's procedure and your facility's policy - this is general reference, not a schedule for this specific unit.
- ·Follow the manufacturer's PM schedule
- ·Perform incoming and annual electrical safety testing per facility biomedical program
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: Weak or no blade motion
- Fit a fresh blade and confirm it is fully seated in the handpiece.
- Test the handpiece at low and high speed in both directions.
- Substitute a known-good handpiece if available.
- Check the footswitch and connections.
- Escalate a confirmed console drive fault to the manufacturer.
Symptom: Poor suction / no irrigation
- Clear the blade lumen and flush the handpiece.
- Check the suction canister and line, and the wall / pump vacuum.
- Confirm the irrigation bag, spike and pump segment are set up correctly.
- Replace the irrigation tubing / pump segment.
- Verify suction and irrigation at the blade tip.
Technical Specs
- MRI safety
- Labeling does not contain MRI Safety Information
- Sterile
- No
- Single use
- No
- Prescription use
- Rx only
- FDA distribution status
- In Commercial Distribution
- Device type (GMDN)
- Electrosurgical handpiece, reusable
- FDA product classification
- DRILL, SURGICAL, ENT (ELECTRIC OR PNEUMATIC) INCLUDING HANDPIECE
Typical Location
Where this class of equipment is typically deployed - general reference, not this unit's own placement record.
- Varies by device - check the unit's own manual for facility placement guidance
Documents & Manuals
No documents available for this device yet.
Troubleshoot this device with Bio
Describe a symptom or error code. Bio answers from this device's own documented error codes, failure modes, parts, and guides.
Ask Bio