Olympic Medical Berkeley VC-10
Olympic Medical · Model Berkeley VC-10
Complete system - The VC-10 comes as a complete, ready-to-operate system and is designed to accommodate the safety and space requirements of hospital operating room and clinic environments. Foot pedal operation - The system includes the option for the physician to operate suction with a foot pedal. Automatic shut off - The system comes equipped with a dual collection bottle system and a safety trap for automatic vacuum shut off.
Key tips
- ·Always leak-test under load - a regulator that reads correctly at rest can still leak and fail in real use.
- ·Canister and tubing changes are an infection-control issue as much as a mechanical one.
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
Low or no suction
HighSymptoms: Weak or no vacuum at the patient port, slow to pull down, will not reach rated vacuum.
Root cause: Worn pump diaphragm / vanes, an air leak in the lid / tubing / overflow float, or a blocked filter.
Overflow / hydrophobic-filter blockage
MediumSymptoms: Suction drops suddenly, fluid near the pump, filter wet.
Root cause: Overflow shut-off triggered or a saturated / clogged bacteria filter.
Motor / pump fault
MediumSymptoms: Pump noisy, hot, runs slow, or trips its thermal cut-out.
Root cause: Worn motor bearings or pump head.
Battery will not hold charge (portable)
MediumSymptoms: Short run time, will not power on off mains.
Root cause: Aged battery.
Vacuum gauge / regulator fault
LowSymptoms: Gauge inaccurate or vacuum will not regulate.
Root cause: Gauge or regulator wear.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
Pump diaphragm / vane kit
Class Periodic replacementRel. cost $$R&R Moderate
Hydrophobic / bacteria filter
Class ConsumableRel. cost $R&R Easy
Collection-jar lid seals & float
Class Frequent wear itemRel. cost $R&R Easy
Motor / pump head
Class Major service partRel. cost $$$R&R Difficult
Battery (portable)
Class Periodic replacementRel. cost $$R&R Fairly easy
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| Pump diaphragm / vane kit | Periodic replacement | $$ | Moderate |
| Hydrophobic / bacteria filter | Consumable | $ | Easy |
| Collection-jar lid seals & float | Frequent wear item | $ | Easy |
| Motor / pump head | Major service part | $$$ | Difficult |
| Battery (portable) | Periodic replacement | $$ | Fairly easy |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
PM Checklist
Preventive-maintenance tasks typical of this equipment class. Perform to the manufacturer's procedure and your facility's policy - this is general reference, not a schedule for this specific unit.
- ·Regulator calibration and leak check
- ·Canister / tubing replacement
- ·Annual full PM
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: Low or no suction
- Fit a fresh bacteria filter and confirm the jar lid and seals are intact and seated.
- Cap the patient port and measure the vacuum the pump can pull against a gauge.
- Check the tubing and overflow float for leaks or a stuck shut-off.
- Rebuild the pump with the diaphragm / vane kit.
- Re-verify the rated vacuum and flow.
Symptom: Pump runs but poor performance / noisy
- Inspect the pump head and motor for wear.
- Check for a cracked jar or lid.
- Confirm the regulator and gauge.
- Rebuild or replace the pump head.
- Verify vacuum, flow and noise level after repair.
Technical Specs
- Height
- 38 in
- Length
- 25 in
- Weight
- 110 lbs
- Width
- 18.3 in
Typical Location
Where this class of equipment is typically deployed - general reference, not this unit's own placement record.
- Operating Room
- Emergency Department
- Patient floors (wall suction regulators)
- Central vacuum plant
Documents & Manuals
No documents available for this device yet.
Troubleshoot this device with Bio
Describe a symptom or error code. Bio answers from this device's own documented error codes, failure modes, parts, and guides.
Ask Bio