Fanem FOG 2140
Fanem · Model FOG 2140
Microprocessor-based controls LED display Indicates temperatures of the heat plate, chamber outlet and close to the patient Audible and visual alarms Indicates when equipment is on and heating Double sensor for monitoring temperatures close to the patient and at the water chamber outlet Compatible for use with mechanical ventilators.
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
Not producing humidity / output low
HighSymptoms: Dry gas to the patient, low or no mist, chamber not warming.
Root cause: Heater element or sensor fault, chamber not seated, or a water-level / feed fault.
Over-temperature alarm / shutdown
MediumSymptoms: High-temperature alarm, heater cuts out.
Root cause: Sensor or control fault, or a chamber run dry.
Water chamber / auto-feed fault
MediumSymptoms: Chamber runs dry or overfills, water-out alarm.
Root cause: Float valve or auto-feed fault, or a cracked chamber.
Heater-wire circuit fault (heated circuit)
MediumSymptoms: Rain-out in the tube, heater-wire alarm.
Root cause: Open heated breathing circuit or a heater-wire adapter fault.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
Heater base plate / element
Class Major service partRel. cost $$R&R Difficult
Temperature sensor / probe set
Class Frequent wear itemRel. cost $$R&R Fairly easy
Water chamber
Class Frequent wear itemRel. cost $R&R Easy
Auto-feed / float valve
Class Periodic replacementRel. cost $$R&R Moderate
Heater-wire adapter
Class Periodic replacementRel. cost $R&R Fairly easy
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| Heater base plate / element | Major service part | $$ | Difficult |
| Temperature sensor / probe set | Frequent wear item | $$ | Fairly easy |
| Water chamber | Frequent wear item | $ | Easy |
| Auto-feed / float valve | Periodic replacement | $$ | Moderate |
| Heater-wire adapter | Periodic replacement | $ | Fairly easy |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: Low or no humidity
- Confirm the chamber is seated and has water.
- Check the temperature probes and connectors; swap in a known-good set.
- Confirm the heater draws current.
- Check the heated breathing circuit and adapter.
- Replace the heater base plate if it will not heat.
Symptom: Over-temperature alarm
- Confirm the chamber is not dry.
- Compare the displayed temperature to an independent probe.
- Replace the temperature sensor if it disagrees.
- Power-cycle and retry.
- Refer for service if the heater runs away with a good sensor.
Documents & Manuals
No documents available for this device yet.
Troubleshoot this device with Bio
Describe a symptom or error code. Bio answers from this device's own documented error codes, failure modes, parts, and guides.
Ask Bio