Covidien Filac 3000 AD
Covidien · Model Filac 3000 AD
Fastest Predictive Readings. 3-5 seconds Oral Quick Mode. 6-10 seconds Standard Mode. 60-120 seconds Direct Mode Easy to Use. Intuitive icon based user interface. Easy to read LCD display with backlight. Durable, robust design; stands upright on a flat surface Supports Infection Control. Interchangeable, color coded isolation chambers, probe and probe cord. Single use durable probe covers minimize cross contamination. Self contained isolation chamber design.
Typical Failure Modes
Compiled for this model from its own documentation and established engineering knowledge for this equipment class - not from a verified service record. Confirm against the manufacturer's service manual.
Slow or inaccurate predictive readings
HighSymptoms: Readings take longer than the 3-5 s (oral quick) or 6-10 s (standard) window, or disagree with a reference.
Root cause: Worn probe, ambient temperature outside range, or the wrong mode selected.
Probe fault
MediumSymptoms: Error icon, no temperature, erratic readings.
Root cause: Damaged probe tip or cable, or a contaminated probe.
Battery low / will not power on
MediumSymptoms: Low-battery icon, dead unit.
Root cause: Depleted AA cells (access by removing the isolation chamber and opening the battery door).
Isolation chamber cross-contamination / damage
LowSymptoms: Cracked or missing isolation chamber, probe-cover fit issues.
Root cause: Wear or a drop - the chamber can be replaced inexpensively instead of cleaning.
Serviceable Parts & Consumables
Serviceable items for this model, compiled from its documentation and engineering knowledge for this equipment class. Service class and relative cost are estimates, not manufacturer figures; no part numbers are given. Confirm intervals and pricing against the manufacturer.
Oral / rectal probe assembly
Class Periodic replacementRel. cost $$R&R Easy
Isolation chambers
Class Frequent wear itemRel. cost $R&R Easy
AA batteries
Class Frequent wear itemRel. cost $R&R Easy
Probe covers
Class ConsumableRel. cost $R&R Easy
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| Oral / rectal probe assembly | Periodic replacement | $$ | Easy |
| Isolation chambers | Frequent wear item | $ | Easy |
| AA batteries | Frequent wear item | $ | Easy |
| Probe covers | Consumable | $ | Easy |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
Error Codes
Extracted directly from this unit's own service manual.
E01System error during synchronization
E02System error during patient thermistor calibration
E03System error during heater thermistor calibration
E04System timing error
E05Heater error
E06LCD communication error
E07Shut off error
P01Probe configuration (or no probe connected) error
P02Direct Mode patient thermistor unstable or out of range
P03Direct Mode heater thermistor unstable or out of range
P04Predict Mode patient thermistor unstable or out of range
P05Predict Mode heater thermistor unstable or out of range
P06Unable to pre-heat probe tip
Troubleshooting Approach
A starting sequence for this model, compiled from its documentation and engineering knowledge for this equipment class. Follow the manufacturer's service documentation for the actual procedure.
Symptom: Slow or inaccurate readings
- Confirm the correct mode (oral quick / standard / direct) for the site.
- Check the ambient temperature is within the operating range.
- Inspect the probe tip and cable; shake out any cleaning solution and dry the contacts.
- Verify against a reference thermometer.
- Replace the probe if it is out of tolerance.
Symptom: Battery / power problem
- Remove the isolation chamber (depress the side tabs and slide up).
- Open the battery door and fit fresh AA cells.
- Dry the battery and probe electrical contacts.
- Power on and confirm the display check.
- Replace a cracked isolation chamber.