ALADP HEALTH LIMITED · Model EB2M20
The Adhesive Electrodes are intended for use as a reusable, conductive adhesive interface between the patient’s skin and the marketed electrical stimulators (i.e. TENS (Transcutaneous Electrical Nerve Stimulation), EMS (Electrical Muscular Stimulation), IF (Interferential) or PGF (Pulsed Galvanic Stimulation) for transmitting electrical current. The electrode is for OTC (Over-The-Counter) or Prescription use.
Intended use: A component of an interferential electrical stimulation system designed to conduct electrical currents from the system's pulse generator to specific areas of the body typically to treat pain. In interferential treatment it is typical to use two electrical conductors (electrodes) that are attached to the patient's skin at opposite corners of a square along which currents are delivered (e.g., 4000 and 41000 Hz) that interfere at its centre. This results in a beat frequency at the difference between the frequencies and this is used to treat muscle disorders or, at higher frequencies, to relieve pain. This is a reusable device.
Failure patterns typical of this equipment class - general BMET reference, not verified against this exact unit's own service history unless flagged. Severity is a category-level estimate.
Symptoms: Poor stimulation, skin irritation.
Root cause: Adhesive/surface wear.
Symptoms: Intermittent stimulation, no output on one channel.
Root cause: Repeated flexing at connector.
Symptoms: Output won't adjust, stuck at one level.
Root cause: Potentiometer or control board wear.
The parts a BMET typically services on this class of equipment. Service class and relative cost are general engineering estimates for the category, not figures from this unit's documentation. Part numbers appear only when pulled from this unit's own service manual. Always confirm intervals and pricing against the manufacturer.
Consumable.
| Part | Service class | Relative cost | R&R difficulty |
|---|---|---|---|
| Rechargeable battery | Periodic replacement | $ | Fairly easy |
| TENS / stim electrodes Consumable. | Consumable | $ | Easy |
| Lead wire set | Frequent wear item | $ | Easy |
Relative cost: $ lowest · $$$$ highest service-part cost for this equipment class. Not a price.
Preventive-maintenance tasks typical of this equipment class. Perform to the manufacturer's procedure and your facility's policy - this is general reference, not a schedule for this specific unit.
A structured starting point derived from the failure modes above. Follow the manufacturer's service documentation for the actual procedure.
Where this class of equipment is typically deployed - general reference, not this unit's own placement record.
No documents available for this device yet.
Describe a symptom or error code. Bio answers from this device's own documented error codes, failure modes, parts, and guides.
Ask Bio →